The Speed Queen Heavy Duty commercial washing machine is equipped with a Reset Button. When the machine needs to be reset, simply press and hold down on the power button for 10 seconds. The machine will then go into a special diagnostic mode, changing the status light from green to orange. The next step (after checking the drain pipe and water supply) is to unplug and re-plug in the machine and wait for it to boot up again.
There are two methods for resetting a speed queen. If the washer is not turning on, you can try to resister the reset button on the front of the machine with a screwdriver or something rigid. If this does not work, you will have to remove the top panel from the machine and inspect the circuit breaker on the right side. Take off two screws and carefully slide open a small metal cover that has slots in it.
The first potential issue with the dryer is that it has a low voltage. The power cord needs to be checked to ensure that it is in good condition and plugged into an outlet. If the power cord is in good condition, the breaker for the outlet may have gone out or one of the wires in the cord might have broken. Secondly, there could be a problem with the heating element inside of the dryer.
The thermal fuse is located inside the dryer’s drum. It will be in one of two places, either below the lint screen or behind the rear panel. The thermal fuse is a safety device that protects the dryer from overheating when it does not have sufficient air flow. If you are unable to locate the thermal fuse, it may have been removed by a previous owner or repair technician.
The dryer is set to manual mode by pressing the toggle switch located on the front left of the dryer. This switch will not be accessible if the door is closed or if the dryer has been turned off using the power button on the front panel. The toggle switch has three positions: on, off, and manual. Pressing the toggle switch toggles between these settings, with manual being towards the back of the machine.
In order to unlock a Speed Queen commercial washer, you must first locate the four screws in the base of the machine, and remove them. Next, turn the dial on the control panel counterclockwise until “LOCK” light is off. Once that’s been done, press and hold both buttons for 10 seconds. Finally, look for a green light next to “LOCK” to know that it was successfully unlocked.
The Speed Queen washer is not starting because there is a potential issue with the door latch. It may be that the springs or latches are old and tired and unable to hold the door closed tightly. This will cause the washer to not get locked into place and start. It could also be that the door lock has worn out, which causes it to not lock in place and spin properly.
It is possible that a fault in the motor has occurred. If this is the case, then your washer will blink for approximately 10 minutes before shutting down.
There are many factors that could lead to a dryer not drying. It is important first and foremost to check for blockages. If the dryer has been running for an extended period of time, it may be necessary to detach the rear panel of the dryer and release any items caught in this area. The lint filter can also become clogged with fabric and clothing (any material that piles such as bedding).
The dryer is not turning off because the circuit breaker is shut off.
Many consumers experience a dryer shutting off mid-cycle for various reasons. The first and most common culprit is the lint screen. If there is a build up of lint and other debris on the screen, it could prevent air flow through the drum and cause your dryer to shut off. Check your lint screen before running another load. The second reason may be that you have set an incorrect cycle for what you are drying.
Some users may be curious about how to check the thermal fuse on a Speed Queen Dryer. This is made easy by entering the dryer and pulling the fuse out. From there, it’s possible to see if the filament inside is intact or not. If it’s not intact, then this means that there was some sort of power surge while operating the dryer. The user would need to replace this part before using the dryer again in order to prevent damage.
